Forum: Engine, Drivetrain

* I have an indy 470 with approximately 600 hp. It is gonna be used as a street car with a trip or two to the strip. I am using a 727. Can I get a 26...

96 Serria 4x4, 5.7 throttle body injection. Parked it Sat. night and Sunday morning all it does is crank. Power timing light indicates a spark. I...

I have a practically brand new Holley 750 double pumper I picked up on ebay for my 400. The 400 expired before I ever got to run it so I am now...

Does anyone have a photos or diagram of the factory big block kickdown linkage for a 67 cuda with 383. Mine seems to be all original but the bar that...

check it out. ...

I'm wonderng what would a good cam duration for a 318 in a daily driver smogger 8.4:1 stock comp ratio, probably will be altered to around 9.0:1, and...

Whats needed to launch hard or pull front wheels up. Besides Hp its there a specific gear ratio or something.

i am swapping my performer rpm cam out for a 268 duration comp extreme enery as many of you recommended. should i install it straight up or should i...

i have a 1975 dodge dart swinger with the stock 225 slant 6, and i just found a 440 and 727 trans for sale. what mods would i have to make to the...

does anyone know the specs for the length on a fuel pump push rod for a 383. i pulled mine out and it seems abnormally worn on the end that rides on...

I soon will be changing u joints on my driveshaft. I was thinking, while I have this done if it would be worth it to have an aluminum driveshaft...

Found this link that might be useful to others. It has specs on 440 blocks over the years, wall thickness, hardness etc. ...

Started installing my Pypes stainless Race Pro exhaust today, great quality so far, I have the mufflers hung, the tailpipes tacked into the mufflers,...

how do you calculate your cylinder preassure to a compression ratio? Is it even posssible ?

Hi guys. I was just looking at the new intake I am going to put on my 383 and was wondering if it would hurt anything if I were to grind off the webs...

i am in the prosses of putting my dart back to stock. the shifter i got off ebay has no linkage does anyone have these parts or does anyone know of a...

I would appreciate some input on what I am considering doing. I was going to put a stroked 340 in my 69 Dart (currently /6 automatic) but have been...

i just picked up a block from the machine shop that i had bored. i was shocked to see the bill was $180. thats $22.50 a cyl.!!! is this what it costs...

Hello everyone!* I've had many V-8 engines in and out of cars but where is the best place to hook onto a slant six for removal?* I realize I have to...

Anyone runing the stealth heads from 440 source and if so, what is it you found good or bad about them.A Friend of mine is looking at them and was...

Does anyone have any experience of Superior Automotive in Anaheim Calif. ? A guy that mentioned them to me said he supposedly knows his stuff about...

I believe I read that the fuel line and power cable? have to be covered by steel pipe where they pass the converter. Can I run them on the outside of...

Picked up My motor. Still have a lot to do,carb,weld baffles in oil pan and route the oil pick-up. Just a street car but getting pumped!!!

I know this has been asked before, but here goes again. I have a 400 block with a good bore. I am thinking of putting together a 451 on the cheap......

Does anyone remember the name of the company that manufactures MLS head gaskets? It's not Cometic. I can't for the life of me remember the name and I...