Pages: [1] 
|
 |
|
 Author
|
Topic: Rear end cleaning before assembly question (Read 276 times)
|
6ix5ive
Guest
|
Hello,
I am about to reassemble an 8-3/4" rearend and I wanted to know if anybody had any tricks for cleaning the differential and axle housing prior to assembly. Any help is greatly appreciated.
Have a good day,
|
|
|
|
|
Logged
|
|
|
|
|
NYrr496
|
Ive had the empty housings sandblasted, I've pressure washed them, I've placed them in big parts washers.(I used to own a diesel generator repair facility). When i was a kid, and bucks down, I once cleaned a housing wiyh mineral spirits and scotchbrite. Worked pretty damn good. I used Brake Cleaner on the inside and pushed shop rags through the axle tubes.
|
|
|
|
|
Logged
|
It takes a Mopar to catch a Mopar.
|
|
|
|
SIKPUP
|
Late night trip to the local coin opperated car wash  .after the attendent guy goes home !  Also works with well with other greasey parts ! Smaller parts ....Dishwasher  SIKPUP |
|
|
|
|
Logged
|
 Spring City, Pa. |
|
|
|
eldubb440
|
Late night trip to the local coin opperated car wash .after the attendent guy goes home ! Also works with well with other greasey parts ! Smaller parts ....Dishwasher SIKPUP great minds think alike  |
|
|
|
|
Logged
|
Mopars, AMCs, and a pile of 65 Satellite
You're all worthless and weak; now drop and give me twenty!
|
|
|
|
SIKPUP
|
Late night trip to the local coin opperated car wash .after the attendent guy goes home ! Also works with well with other greasey parts ! Smaller parts ....Dishwasher SIKPUP great minds think alike The best part about the dishwasher is, the paint drys quicker because the parts are hot..... |
|
|
|
|
Logged
|
Spring City, Pa. |
|
|
|
jamesdart
|
for my housing tubes i took a 3/8 piece fo rebar, stuck it in a drill, wrapped a rag around it and a green scotchbrite aroung that, soaked it in laquer and ran it through until the tubes were spotless.
|
|
|
|
|
Logged
|
|
|
|
|
GON_RACIN
|
if the housing is still under the car and you dont want to pull it, you can use a broom handle or something and shove paper towels soaked with brake clean down through the tubes.
|
|
|
|
|
Logged
|
|
|
|
|
GTS225
|
I checked out a Dana 44 in a 4X4 Scout, and to clean the inside of the axle tubes, I used a chunk of 1/2" EMT conduit screwed to the handle of a new toilet brush. Had some solvent in a 1-gallon garden sprayer, and used a jack to tip the housing to one side or the other. (I wanted the grunge to run toward the outer ends.) Worked pretty darn good, and I didn't have to yank out the housing, although I did discover the lockouts were junk.
I would imagine one could use simple green instead of the solvent.
Roger
|
|
|
|
|
Logged
|
|
|
|
|
Pages: [1] 
|
|
|
 |
