Pages: [1] 
|
 |
|
 Author
|
Topic: Wire Gauge for Disconnect Switch (Read 180 times)
|
rapom
Jr. Member
 Offline
Posts: 33
BigBlockDart.Com
|
Hey All,
Looking for some help on wire gauge. I put my battery box in the trunk of my '69 dart, it is a street car that will see some strip time. I'm putting a battery disconnect switch w/alt in the rear bumper, the two main battery feeds are 0 gauge. What gauge should the smaller lugs have on them? (one goes to the battery & the other to the alternator) ?? I was thinking 6 or 8 gauge. What are you guys using? Thanks for the help.
|
|
|
|
|
Logged
|
|
|
|
|
bOb shingler
|
that's about right.
|
|
|
|
|
Logged
|
"bOb Built" (no matter how many times it takes)  |
|
|
|
jacks62440
|
About your disconnect switch in your bumper  I put a push/pull rod on my switch and then I disconnected the rod for street use and put a plug in the hole. That way you can hook it up for Strip use. It would be a Bummer to have some "Smart Ass" run out and Shut you Down at a Stop Light  |
|
|
|
|
Logged
|
Jack
|
|
|
|
Pages: [1] 
|
|
|
 | 
