Pages: [1] 
|
 |
|
 Author
|
Topic: 2003 Ram 1500, (Read 243 times)
|
BabyBlue383
Jr. Member
 Offline
Posts: 53
BigBlockDart.Com
|
I own a 03 dodge ram 1500. It has a factory trailer plug on it and only one side works. I tried to take it off to get another one but as soon as I cut the old one off the truck would not start. Whats the deal? and has anyone else had this problem? How do I fix this?
|
|
|
|
|
Logged
|
|
|
|
|
blown71duster
|
Maybe it's possible when you cut the harness that you blew a fuse , did you check all the fuses ? Usually the plug has a 12 volt feed to the trailer
|
|
|
|
|
Logged
|
1971 Duster 440 Single turbo
|
|
|
|
drjay0
|
That year and mine (2004) and I'm sure other factory tow preps have its own fused circuits located in the box in the engine compartment on the drivers side. I would start pulling some minis out and start there.
|
|
|
|
|
Logged
|
263 Posts on old board. Member since March 2003.
"Where the hell do i go to tell the world my dog died or my gf is in jail or my penguin ran away!" -njsuperbees
|
|
|
BabyBlue383
Jr. Member
Offline
Posts: 53
BigBlockDart.Com
|
I was told that it makes the computer circuit open when I cut and when I hooked it back up it closed it then the truck start right up.
|
|
|
|
|
Logged
|
|
|
|
|
Pages: [1] 
|
|
|
 | 
