Welcome, Guest. Please login or register.
September 07, 2008, 04:44:12 AM

Login with username, password and session length

Visit ReillyMotorSports
* Home Help Search Memberlist gallery Login Register
+  The BigBlockDart Message Board
|-+  Technical
| |-+  Body, Paint, Interior, Wiring
| | |-+  trunk mount battery install
Pages: [1] Go Down Print
Author Topic: trunk mount battery install  (Read 300 times)
408 dart
Jr. Member
**
Offline Offline

Posts: 34

BigBlockDart.Com


Email
trunk mount battery install
« on: June 28, 2007, 12:35:32 AM »

if i run positive wire inside car on drivers side, how do i get it through floor to starter or to selonoid
Logged
Capt Jack
BBD God
*****
Offline Offline

Posts: 1626


San Diego, CA


Re: trunk mount battery install
« Reply #1 on: June 28, 2007, 12:53:48 AM »

I ran it under the drivers kick panel and used one of the long abandoned holes in the firewall.  it had a rubber plug in it, near the steering column left side.  sealed it up good after using some heavy wire ties on each side to keep it located but away from sharp metal edges
Logged

a pirates life for me
jacks62440
Sr. Member
****
Offline Offline

Posts: 555

BigBlockDart.Com


Re: trunk mount battery install
« Reply #2 on: June 30, 2007, 04:11:00 AM »

Why not keep it outside Huh  You can just run it through grommets . Something else you could do is put a master disconnect switch under your seat as a anti theft device, Also a handy shut off. I put my cable through a hole in my frame inside a spare piece of AN 10 fuel line to insulate it     drinks


* Finished Trunk.jpg (30.65 KB, 640x480 - viewed 100 times.)

* Under Carriage + Battery Cable.jpg (38.54 KB, 640x480 - viewed 102 times.)

* Master Disconnect.JPG (64.51 KB, 640x480 - viewed 101 times.)

* Aeroquip AN 10 Grommet through Frame.jpg (28.95 KB, 640x480 - viewed 100 times.)
Logged

Jack
Pages: [1] Go Up Print 
Jump to:  

Powered by MySQL Powered by PHP The BigBlockDart Message Board | Powered by SMF 1.0.5.
© 2001-2005, Lewis Media. All Rights Reserved.
Valid XHTML 1.0! Valid CSS!