early 4-speed specific????

[whiplash]

I scored a nice 4-speed,and I have a small block bellhousing.What specfic early a-body parts will I need to install.and what 67 up a-body parts would work with alittle to alot of modifing( I got some skills..)?pivot,z-bar,clutch rod.clutch arm.etc
This going an a 64 Valiant,with a 69 340.

[340fyd]

The tranny will be fine as long as it's a short tail shaft, which if it was out of an a-body then it is.  The newer bellhousing will be a little tight, but it will work some have done it, you may have to bend the pinch weld up for it to clear.  Brewer's sell the z-bar and stuff for the 10.5 clutch stuff to work.  You'll need a newer drive shaft so that you'll have the slip in yoke.

Hope this helps.

Lee

[whiplash]

The car has a 340/727 now so the tunnel has been clearanced alittle.340fyd you know of the car,it was at a show in carthage a couple of years ago.

[6469mopar]

   whiplash post some more pics of that 64     

[340fyd]

The car has a 340/727 now so the tunnel has been clearanced alittle.340fyd you know of the car,it was at a show in carthage a couple of years ago.

Did you buy it off of a member here?  Dave?

You live in MO?

Lee

[340fyd]

From the looks of the hood in the picture you showed it is.  I missed that show, but my wife seen it though at that show.

Lee

[whiplash]

I`m still the owner.I maybe selling my dart,and wanna play with the Valiant again.

[340fyd]

Cool, you've had it awhile.  Have you not?

[whiplash]

Since 97

[340fyd]

I've always liked your car.  I would like to see up close one of these days.

Lee

[whiplash]

If things go good,I`ll have it at Branson(in june,I think)

[340fyd]

Ok, that would be cool.