Pages: [1] 
|
 |
|
 Author
|
Topic: EZ Wiring harness, anyone use one yet? (Read 427 times)
|
|
flyboy01
|
After I pulled everything out of my engine compartment, and the rear of the car already had the harness pulled, I have decided its time to rewire the car. I am going to order the EZ wiring harness, I found one that has many more curcuits than I need. I am more than capable with any wiring projects, I have even built my own harness once for a Maverick that had an engine fire, so I am not intimidated by it, just wondering if anyone has any opinions.
|
|
|
|
|
Logged
|
|
|
|
|
sunsetdart
|
hey fly..........check out Ron Francis.........I got his catalog and he has so much to offer. Am going with his stuff for my new project.
|
|
|
|
|
Logged
|
|
|
|
|
Ace
|
I've used one and they're great, especially for the money. Just like a Pain-less kit as far as how it's all labeled out for you. I plan on going with a set up from them as well as I had good luck with the first one.
|
|
|
|
|
Logged
|
|
|
|
|
flyboy01
|
I am going to get the EZ because I had one offered to me for under $100 new. I was going to build my own, bu the cost of the individual pieces was not cost effective. I am already planning on customizing this harness, I know the RF and Painless harnesses are good, but they are a bit pricey for me.
|
|
|
|
|
Logged
|
|
|
|
YellowDuster
Newbie
 Offline
Posts: 1
BigBlockDart.Com
|
I used an EZ harness in my Duster. It worked great.  |
|
|
|
|
Logged
|
|
|
|
|
zpsull01
|
I haven't installed it yet but I picked up a 21 circuit EZ harness at a swap meet for under $100 and I am very impressed with its quality and with the extent that its labeled. I'd definately recommend one.
|
|
|
|
|
Logged
|
|
|
|
az426hemi
Jr. Member
Offline
Posts: 83
BigBlockDart.Com
|
I used one on my 66 Hemi Coronet. Very nice setup for the money.
Mike
|
|
|
|
|
Logged
|
|
|
|
|
flyboy01
|
I paid for it, it should reach me in a few days, for $100, I can not complain. Plus, my old harness is almost out already.
|
|
|
|
|
Logged
|
|
|
|
moparsky
Jr. Member
Offline
Posts: 48
BigBlockDart.Com
|
I paid for it, it should reach me in a few days, for $100, I can not complain. Plus, my old harness is almost out already.
Hi FlyBoy1, Does EZ have a bulkhead connector or will you have to close up that OEM hole, just wondering ? Did you go ahead with that neat home made gauge panel you had mocked some time back ? John / Moparsky |
|
|
|
|
Logged
|
|
|
|
|
Pages: [1] 
|
|
|
 |
