What size bolts

[mopowers]

What size bolts are used to attach the trans to the motor?  I need to go get some for mock up.  Thanks!

[Dartdragracer]

I'm pretty sure they are 3/8-16 x 1 1/2", someone please correct me if I'm wrong.
You might as well buy a good quality Grade 8 bolt the first time, just don't torque them for mock-up.

[motorhead]

thats right 3/8-16 should be 5 in from the bellhousing ,,1 in on pass side from motor to bell housing and then the starter uses 7/16

[jet-taz]

go to your chrysler dealer and order 4 no 6027865 and 2 no 6024863 these are the correct bolts for the trans as two outer ones are longer should cost you around 12.00

[mopowers]

Thanks for the responses guys.

go to your chrysler dealer and order 4 no 6027865 and 2 no 6024863 these are the correct bolts for the trans as two outer ones are longer should cost you around 12.00

I will check those part #s out.  I can't imagine spending a whole lot for the correct bolts though.  I may as well get some grade 8s from the hardware store.  We'll see what the dealer gives me for prices.

[jet-taz]

i know it seems alot but buy the time you fine the correct sizes, then playing around with correct head size  ( there's little room now to get wrench/socket ) then correct washers see where i'am going

[68_Val_Sedan]

thanks for those part #s     

[mopowers]

I just checked on those part #s.  My local Dodge dealer wants about $40 for all 6.  I think I'm going to check the hardware store. 

Does anyone have the lengths?

[jet-taz]

your dodge dealer is a crook even at list cost should be 13.76 + tax  4.short ones are1 1/2, 2 long ones are  two

[mopowers]

The short ones are $5.50 and the long ones are 8.something apeice!  F-that!