Holly ignition wiring

[kudah440]

Ok, lets talk about older high capacity discharge stuff.... 
I ran the Holley Annihalator ignition box on my cuda for a couple years (part # 800-100 i think, its been a while) I heard complaints from other people, but it was not a bad unit for me.... but the point is
Last year I pulled all the wires out of the engine bay to clean it up and repair, but I couldnt remember how to wire it in again and could not find wiring diagram.  So it went on the shelf in the garage.
If it was for the bCuda, Id just buy a MSD6AL and be done with it, but I figured Project Scamp is a tight budget project so lets use the parts I have...
... does anyone have wiring diagram or instructions for this thing? When I tried to reinstall it last year Holley was less than helpful.  Instead of we dont have anything for it, it was sorry we just dont support it... weird

[kudah440]

wow, doesnt support it either.   
ok so im at work and bored...

[68_Val_Sedan]

 you have mail !!!

[kudah440]

Wow, thats way too cool!

I owe you a beer next time youre in Kansas City or Im in PA!

[nothingbutdarts]

Hay now, don't leave us out!
                             



Curiosity killed the cat.

[68_Val_Sedan]

it is a multiple page pdf ... i cannot post it ...

[nothingbutdarts]

OK,

                                     

[drgrcr3603]

were did you findthe diagram im getting ready to install a annialator in my dart but dont have the directions either?

[68_Val_Sedan]

you have mail as well

[kudah440]

and thanks again 68_val