Super stock seat aluminum brackets

[warthog]

I am getting ready to break the aluminum for my a100 seats.   I was just going to form them at the height that I thought suited me but I am curious of the measurements of the repro ones out there.   Has anybody ever taken measurements off the originals or the repros they would be willing to share?  Just curious thanks Dan

[68_Val_Sedan]

 

[IL.DART340- 4SP]

This would just be IMO  that the length would be as long as the bottom of the seat track for a bucket seat in a-body. The holes would be drilled or studs installed where the holes are in the floor for a bucket seat car and the height would would be a little taller than a stock track because the van seats are not as tall.

http://cgi.ebay.com/ebaymotors/MoPar-1968-SS-Barracuda-Dart-Alum-Seat-Brackets_W0QQitemZ190222964984QQihZ009QQcategoryZ140726QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

[warthog]

FYI  the a 100 seats that I have do not line up with the factory bucket seat holes, they are narrower.  The a100 mounting holes fall inbetween the bucket seat track holes in the floor.  Thats why the a100 super stock brackets are so much taller then the original trackings for the car. The do not use the factory bumps in the floor, thats why I was curious if anybody actually had hard measurements so I could compare them to the ones that I am making. 

[IL.DART340- 4SP]

OK the seats are not as wide as a standard a-body bucket seat either. Yeah It would be nice to get measurements for you. You already know how much the brackets sell for. For the van seats to positioned in correctly would they not fit in between the holes already in the floor?

[rc1405]

I have a Drawing of the real deal  brackets.  If you send me a fax number i will fax a copy to you.  i have no way to scan it in to the computer or i would send it that way, so get me a fax number.

[68_Val_Sedan]

I pm'd you my fax number.  I'll scan them and post them once I recieve them ...