Pages: [1] 
|
 |
|
 Author
|
Topic: disassembly question (Read 147 times)
|
rfraley
Newbie
 Offline
Posts: 4
BigBlockDart.Com
|
Hello,I'm disassembling a 68 GTS convertible to get it ready to have it media blasted,when I remove the doors should I install some braces in the door jams and across the back (from side to side)? I'm worried the body will buckle.Thanks
|
|
|
|
|
Logged
|
68 GTS 340 droptop
|
|
|
Jim_Lusk
Official BS King
Global Moderator
BBD God
Offline
Posts: 4893
A-bodies since 1978, this one since 1983
|
We've had both my son's 67 Dart convertible andmy 67 Barracuda convertible on stands without the door area supported, BUT I never transported either one that way. It wouldn't be abad idea to make up triangular braces that use the hinge bolt holes and the striker hole. Use a good sized plate at the striker. The back isn't going anywhere.
|
|
|
|
|
Logged
|
7903 posts on old board.
|
|
|
rfraley
Newbie
Offline
Posts: 4
BigBlockDart.Com
|
plus it's going on a rotisserie,do you think 1" x 1" square tube bolted to the upper hinge and the striker be ok? Thanks for your advice
|
|
|
|
|
Logged
|
68 GTS 340 droptop
|
|
|
Jim_Lusk
Official BS King
Global Moderator
BBD God
Offline
Posts: 4893
A-bodies since 1978, this one since 1983
|
I'd triangulate it by using both hinge areas, not just one, but yes that should do the job.
|
|
|
|
|
Logged
|
7903 posts on old board.
|
|
|
|
Pages: [1] 
|
|
|
 | 
