Pages: [1] 
|
 |
|
 Author
|
Topic: DISK BRAKE QUESTION ??? (Read 279 times)
|
|
south tex mopar
|
I was curious, does anyone know what ball joint the 70 -72 disc brake dusters with small bolt pattern have?
|
|
|
|
|
Logged
|
|
|
|
Jim_Lusk
Official BS King
Global Moderator
BBD God
 Offline
Posts: 4923
A-bodies since 1978, this one since 1983
|
Same as all other early (72-earlier) a-bodies have.
|
|
|
|
|
Logged
|
7903 posts on old board.
|
|
|
|
south tex mopar
|
I got wind of a 67 dart parts car about 45 minutes from my house, someone had put disc brakes on it. Just hope they are the newer ones with the large ball joint.
|
|
|
|
|
Logged
|
|
|
|
|
Halfaed
|
In that case, there is only one way to find out.
|
|
|
|
|
Logged
|
|
|
|
|
south tex mopar
|
Well it went well today. TOOKTHE WHOLE FRONT END OF THAT DART APART IN ABOUT 3 HOURS. Im beat. Turned out to be the newer big ball joint, big rotors, large bolt pattern. Also got some 383 torsion bars, manual gear boxl and a v8 k member. The best part was i got it all for free. It dont get much better than that huh. Hey so where do yall think i should buy the master cylinder from? Im looking for good quality and for cheap. Also should i use the prop valve that was on the caror a new one. Thanks
|
|
|
|
|
Logged
|
|
|
|
Jim_Lusk
Official BS King
Global Moderator
BBD God
Offline
Posts: 4923
A-bodies since 1978, this one since 1983
|
I've always just bought master cylinders from the parts store. I haven't had any trouble with them. Use the valve that you got off that car. I've also never had a problem with one of those, either.
|
|
|
|
|
Logged
|
7903 posts on old board.
|
|
|
|
Pages: [1] 
|
|
|
 | 
