Pages: [1] 
|
 |
|
 Author
|
Topic: engine mounts (Read 286 times)
|
madmick
Jr. Member
 Offline
Posts: 12
BigBlockDart.Com
|
hi anybody used mancini engine mount kit to drop a 383 in a, a-body are they any good ? or are schumacher the ones to go for
|
|
|
|
|
Logged
|
|
|
|
|
69 Dartified
|
I don't know what you are dropping your engine in but I am putting my 383 (69 Dart) in with the Schumacher set. I haven't done it yet but I went with them anyway as there isn't too much to modify to make it fit. You just notch out the k-member about an inch square from the layout they provide and slap her in there there should be no problem. I am also going to go with a torque strap/tube as well for more security. I got mine from an outfit out of Oregon(via ebay) for less than what I would've paid here in Seattle. I saved 30.00.  I don't know anything about the Mancini setup other than what I read which said that Schumacher joined up with some other outfit to make them for Mancini to sell. Just my thoughts for you to consider. |
|
|
|
|
Logged
|
|
|
|
madmick
Jr. Member
Offline
Posts: 12
BigBlockDart.Com
|
thanks for that the cars a 73 duster i might just go with schumachers want to be sure of engine position
|
|
|
|
|
Logged
|
|
|
|
tomthumb
Jr. Member
Offline
Posts: 80
BigBlockDart.Com
|
i like shumachers kits there very simple very proffesional no problems they fit wonderful
|
|
|
|
|
Logged
|
|
|
|
Jim_Lusk
Official BS King
Global Moderator
BBD God
Offline
Posts: 4855
A-bodies since 1978, this one since 1983
|
Original V8 car?
If so, take a look at the tech pages...........
|
|
|
|
|
Logged
|
7903 posts on old board.
|
|
|
az426hemi
Jr. Member
Offline
Posts: 71
BigBlockDart.Com
|
I just installed Mancini mounts to put a 360 in my 63 Dart. They were Shumachers.
Mike
|
|
|
|
|
Logged
|
|
|
|
|
Womanator
|
Schumachers are no brainers.Drill the hole on the drivers side mount and trim the mounting pirch and shove the engine in.
|
|
|
|
|
Logged
|
|
|
|
|
Pages: [1] 
|
|
|
 | 
