Stahl Headers
| Pictured below are
the big ones...The 2 1/8" x 38" Stahl Fenderwell headers. At around $1000
a set, they're not cheap, but they're as good as it gets from a performance
perspective. |
| As you can see, assuming
the fenderwells were still here, theres a bit of cutting involved to get
'em in. Also note that one tube
on each side (#7 & #8) is routed under the car. The modified #3 tube
on this car was due to the master cylinder and brake lines, but the owner
says it was only because of the master he chose to use. |
| This is the view
if you're the driver side tire :) You can see clearance and access to most
parts are good, and also where the #7 tube rejoins the other three. |
| The above pics show
how close these monsters come to everything. They do fit however. Also you can see how
the #8 tube wraps around the frame and rejoins the bunch. |
As you can see, the
theme of this car is "BIG". BIG exhaust runs right down the rocker edge.
And check out the BIG oil pan :)
Another good pic of the
#8 tube under the frame. So there ya have it, mega headers for a mega motor. Of course, it's up to you to decide if your own motor is mega-enough for such big tubes. |
|
