Big Block Dart Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
The GT I purchased was nothing more than a shell from a previous 1/4 mile car. I am in the process of restoring it to a streetable version and am replacing the chopped quarters and the full tubs with oem style quarters and minitubs. There is no place evident to secure the rear outer seat belts. My assumption is that they were cut out of the floorpan when the tubs went in. Can someone please provide a picture of where the oem outer seat belt anchors were so I can weld in new ones in the correct location.
Tire Wheel Vehicle Car Window
 

·
Premium Member
Joined
·
3,920 Posts
This is a Barracuda and a convertible so there are a couple of difference, but the location of the seatbelt holes is the same. The two inner holes are pretty obvious. The outer hole is below and outside the upper seat bracket. So, yes it would have been cut out for tubs.



55546
 
1 - 2 of 2 Posts
Top