Big Block Dart Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
I was thinking of putting in an aluminum interior in my duster. Anybody done this and have any install tips. This car isn't tubbed, so the wheel tubs won't be used. Any tips will be apprecialted.
 

·
Registered
Joined
·
4,105 Posts
use your interior side pieces for the templets. transfer them to construction paper. scotch tape them together if needed. make sure they fit good. transfer that to the aluminum. cut them out then roll the beads in. use the vinyl covered sheets of aluminum.



 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top