Big Block Dart Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
o.k. i was reading through the tech pages and it says you can use the stock lower control arms,do you have to?I picked up a 73 disk set up just dropped the whole thing out upper and lower control arms and had planned on replacing the ball joints,bushings checking the bearings etc and and just slapping the whole unit back in.Am i going about this the hard way or should i tear it apart and put it back together as i put it back on?
 
1 - 4 of 4 Posts
Top