Big Block Dart Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
112 Posts
Discussion Starter · #1 ·
Ok guys and gals, I roasted my ring and pinion last saturday afternoon on my 8 3/4. It's time to step up to a dana. My question is, how long is the front section on a dana from the center line of the axle tube to the rear U-joint centerline. I was hoping to keep my aluminum drive shaft and just have it shortened and have the 1310 U-joint attached. If it is shorter than the 8 3/4 I will have to get a new drive shaft....... What do you think?

Bill,

[attachment deleted by admin]
 

·
Registered
Joined
·
112 Posts
Discussion Starter · #5 ·
Thanks Tom, thats exactlly what I wanted to hear. My 8 3/4 is 12.5" so I can cut the drive shaft and put the new u-joint on and go.....
 
1 - 9 of 9 Posts
Top