Big Block Dart Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
I just noticed that the stock outer axle seals wont work with my green bearing/yukon axles set up. I bought the bearing kit through summit and the seals didnt come with the kit. Is there a part number for them, I couldnt find any in my catalogs.

Fred
 

·
Registered
Joined
·
311 Posts
the green bearings should have an O ring on the outside of the bearing that replaces the factory wheel seal. You can still run the factory wheel seal if you like, you just have to beat it farther into the axle tubes so it will clear the green bearings.
 

·
Registered
Joined
·
60 Posts
Time out folks, remember there are 2 types of green bearings. If you have the style where the backing plate is crimped to the bearing, the bearing will be o-ringed. The style where the backing is seperate from the bearing will not have the o-ring, but is supplied with a new inner axle seal. It will have a axle end gasket and the bearing has a snap ring. Either style works nicely. Tom
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top