Big Block Dart Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
164 Posts
Discussion Starter · #1 ·
Does anyone know what the factory spec is for the wheel locating flange diameter is for a 5 on 4.5" bolt pattern? I have measured my old stock axles but the number is not a common one. I wonder how much has rusted away. I am about to order axles and I have a non standard brake set up. The hole in the rear rotors is about .030 smaller than the end of a mopar axle so I want to take it out to that size too. Any info is greatly appreciated. Thanks Dave
 
1 - 2 of 2 Posts
Top