Big Block Dart Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
147 Posts
Discussion Starter · #1 ·
need to no if the pinion offset on a dana 60 is the same as a 8 3/4. The one i have was cut once for a nova,now i have to put in the rite location for a 72 dart.
 

·
Registered
Joined
·
147 Posts
Discussion Starter · #3 ·
bob shingler I'm sorry i didn't mention that i'm back halfing the dart.I wanted to make sure i have the cross member in the rite place,so the drive shaft will clear. It will have a 4 link in it
thanks joe
 

·
Registered
Joined
·
4,105 Posts
no much of a different answer but center the dana with the frame rails and the fenders and then see where you need to put the cross member.



 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top