I've swapped yokes on an 8-3/4" while leaving the chunk in the car, but I've never tried the pinion seal. Can the pinion seal on a 489 be changed while leaving the chunk in the car? after pulling the yoke?
Dont forget when reassembling to use a little silicone under the washer.
If you dont grease can run through the splines and out the yoke and it will look like a pinion
seal when it really isnt. doh
Ive seen it a few times 0/
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Dodge Dart owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!