Big Block Dart Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
529 Posts
Hi,
When I installed the Schumacker mounts on my Dodge, I had to use spacers to lift the engine to get clearances I needed. Unfortunately the mounts don't fit every car the same way. Is it possible you have the wrong mounts? The engine mount studs should line up with the K frame hole. With the trans bolted to the original spot on the transmission mount.
 

·
Registered
Joined
·
529 Posts
Hi,
If you end up with an oil filter clearance problem, where the oil filter hits the k frame you can use a smaller diameter oil filter. I'm using a Wix 51516. It fits where the PF8A won't.
 
1 - 2 of 2 Posts
Top