Big Block Dart Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I'm planing a stroker of my -69 HP 383 engine and looking at 440 source's strokerkit.
It's a lowmile engine and i really don't wanna do a .030 bore, it's in very good shape.

I mailed them and asked if they could sell me std.pistons, but they couldn't.
Is there any alternative pistons out there, at std.size, that I can use together with the strokerkit?
 

·
Registered
Joined
·
692 Posts
400 blocks are plentiful and cheap, why not just leave your virgin 383 bottom end alone and stroke a 400?
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #3 ·
Well, I live in Sweden, so the 400 is not that common here...
My 383 have had a manual trans behind, so the crank have a lot of axial play, so it need a new crank anyway...
But very nice bore!! :D
 

·
Registered
Joined
·
2,010 Posts
you could get some custom pistons made any size you like by a company like diamond. But your also getting into custom prices. just go .030 on it, and use torque plates. it'll make a nice motor my 2Cents.
 
1 - 5 of 5 Posts
Top