Big Block Dart Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
Doing a disk brake conversion on 71 Demon. I got strut rod bushings and they are a one piece bushing, I have seen some that are a two peice unit with a steel sleeve. In the service manual looks like the A bodies used the one piece. Can someone give me some info on this? Thanks Steve
 

·
Registered
Joined
·
283 Posts
yes i can use the one-piece it made for a bodies . the 2 piece one is for b-bodys . i tried the 2-piece and found way too much play in it.was about 1/4 all around and would'nt fit my hd strut rods. the arrow end doesn't matter which way it goes, i faced mine out only because i'll had my k-frame out. o----o<>
 
1 - 3 of 3 Posts
Top