Big Block Dart Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
1973 dart
727 transmission
8 3/4 rear
I pulled the 400 out and am building a 400 low deck stroker (500ci)
While the motor and trans are out I'm looking to redo the front suspension. Does anybody have some good suggestions?
How is the quality of QA1 level 2 and 3 systrm?
Thanks
 

·
Registered
Joined
·
647 Posts
I did some additional welding on my K frame (perimeter and steering box area) and added plates to the lower control arms. I purchased a full front end kit from PST, which was ok, but would consider other options next time. I have been happy with the products and service from QA1. Andrew
 

·
Registered
Joined
·
9 Posts
Has anyone of you tried getting parts from Mevotech or Moog?

I replaced the LCA about a yr ago or so. Of course, the front end is clunk once again.
Anyway, has anyone ever used mevotech or moog lower control arms for 68 Dart?
 

·
Registered
Joined
·
9 Posts
Has anyone of you tried getting parts from Mevotech or Moog?

I replaced the LCA about a yr ago or so. Of course, the front end is clunk once again.
Anyway, has anyone ever used mevotech or moog lower control arms for 68 Dart?
I did my own research.

I would have to consider buying tie rods and other bushing that might need replacements once I take the LCA down. Due to my curiosity and wanting to know the difference between the two, I chance upon this link that helped decide between Mevotech or Moog. It has comprehensive motoringcrunch.com/reviews/mevotech-vs-moog/ and a good read. I am now considering getting Mevotech.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top