Big Block Dart Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
when i'm banging them out where is the resistance going to be? at the control arm or the rear housing?or both?wondering if i need to clean off the whole bar so it will slide out easier or do i just clean enough to exit the control arm?thanks for any help.
 

·
Registered
Joined
·
38 Posts
Most of the stuck bars I have delt with were stuck in the control arm end.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top