Big Block Dart Forums banner

wiper arm bushing upgrade

4662 Views 8 Replies 4 Participants Last post by  sweatybetty
G
well its winter and rainy crappy weather, so im doing all the little bs stuff. heres some pics of the wiper linkage bushing upgrades. these bushings are from a early 70s throughlate 80s mopar. i got these at napa

pic 1 drill out the hole to 35/64" and use a 1/8" file to cut the slot. the slot keeps the bushing from spinning

[attachment deleted by admin]
1 - 9 of 9 Posts
G
pic 2 press the bushing into the arm and then ream it out with a 3/8" drill bit. it will fit tight over the pivot stud but i used a bit of oil and it fits sweet. snap the retainer clip on and your done

[attachment deleted by admin]
G
heres the finished piece

[attachment deleted by admin]
G
and the part #

[attachment deleted by admin]
Can this get put into a Tech file/page on the site?
GT_convert. said:
Can this get put into a Tech file/page on the site?
I second this
G
if anyone needs more detailed pics or whatever let me know. i was trying to upgrade to more modern (available) stuff. the originals were brass. this should work on the later a bodies as well. thanks for all the comps tnku
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top